2.
Press the
▼
button to advance the roll to the position for cutting.
3.
Press the
Cut
button.
4.
Press
▲
or
▼
to select
Yes
, and then press the
OK
button.
After the roll paper is cut, it is rewound automatically.
Cutting the Leading Edge of Roll Paper Automatically
If the leading edge of a roll is crooked or warped, it may cause an error message or printing problems. In this case, set
Trim
Edge First
to
Automatic
or
On
on the Control Panel to have the printer cut the leading edge to make the edge straight after
you load a roll.
Trim Edge First
offers the following options.
•
Automatic
If the left and right side of the leading edge of the roll ((a) and (b)) are uneven by 40 mm (1.6 in) or more when you
load the roll, the edge is cut an amount relative to the slant to ensure a straight edge, and scraps are removed. The edge
is not cut if the unevenness is less than 40 mm. However, paper may sometimes be cut, depending on the state of the
leading edge.
•
Off
The edge is not cut and scraps are not removed.
Handling Paper
>
Handling rolls
>
iPF8300
Cutting the Leading Edge of Roll Paper Automatically
7
799
