Interface Settings
2-10
2
Settings Common to the Netw
o
rk
Protocols
IMPORTANT
If you reconnect the network cable (for example, reconnect the cable to a different
Ethernet hub) with the power ON, the Auto Detect function will not work even if you
set <Auto Detect> to [On]. (Connect the cable with the power OFF.)
NOTE
The default setting is 'On.' Use the [Off] setting when you want to specify a
particular Ethernet setting.
6
Specify <Communication Mode> on the Ethernet Driver
Settings screen.
●
If you want to alternately send and receive:
❑
Press [Half Duplex].
●
If you want to simultaneously send and receive:
❑
Press [Full Duplex].
7
Specify <Ethernet Type> on the Ethernet Driver Settings
screen.
●
If you want to establish a 10Base-T network connection:
❑
Press [10 Base-T].
●
If you want to establish a 100Base-TX network connection:
❑
Press [100 Base-TX].
8
Confirm the settings you specified
➞
press [OK].
The display returns to the Network Settings screen.
9
Press [Done] repeatedly until the Additional Functions screen
closes.
10
Restart the machine.
❑
Turn OFF the machine, wait at least 10 seconds, and then turn it ON.
E210_NWG_US.book Page 10 Wednesday, August 18, 2004 3:40 PM
