NetWare Print Service Settings
4-6
4
Using a NetW
are Netw
o
rk
(Windo
ws)
4
If you are using the remote printer mode, start the print
server.
❑
If you are using the NetWare file server as a print server, enter <Load
PSERVER.NLM> in the file server
➞
press [ENTER] on the keyboard.
NOTE
If you are using the queue server mode, this step is not required.
NetWare print service settings are complete. Proceed to "Protocol Settings," on p. 4-9.
Using PCONSOLE in the Queue Server Mode or Remote Printer Mode
in the Bindery Mode (NetWare 3.2)
1
Log in to NetWare as Supervisor, and then start PCONSOLE.
2
If you have not set up a print server yet, set up the print
server.
❑
On the [Available Options] menu, select [Print Server Information]
➞
press
[ENTER] on the keyboard.
❑
Press [INSERT] on the keyboard.
❑
Enter the name of the print server you are setting up
➞
press [ENTER] on the
keyboard.
❑
Press [ESC] on the keyboard to return to the [Available Options] menu.
NOTE
Be sure to remember the name of the print server. You need it to specify the
printer's protocol settings.
3
Set up a Queue, and then assign the print server to the queue.
❑
On the [Available Options] menu, select [Print Queue Information]
➞
press
[ENTER] on the keyboard.
❑
Press [INSERT] on the keyboard.
❑
Enter the name of the queue you are setting up
➞
press [ENTER] on the
keyboard.
❑
Select the name of the queue you specified
➞
press [ENTER] on the keyboard.
❑
Select [Queue Servers]
➞
press [ENTER] on the keyboard.
E210_NWG_US.book Page 6 Wednesday, August 18, 2004 3:40 PM
