Setting Up a Computer for Printing
6-8
6
Using an AppleT
alk Netw
o
rk
(Macintosh)
Setting Up a Computer for Printing
After you have completed the machine protocol settings, install the printer driver on
the Macintosh that will do the printing, and then make the settings for the print
destination.
See the
Network Quick Start Guide
to install the printer driver and to set the port.
IMPORTANT
You can only print from a computer if the optional equipment is installed. For the
equipment needed, see "Optional Equipment and System Environment Requirements,"
on p. 1-2.
NOTE
Select either of the following names displayed in the Chooser. ('xxx' indicates the name
of the printer entered in [Service Name].)
- [xxx_D]: the print job is printed without spooling to the hard disk of the machine.
- [xxx_S]: the print job is printed after it has been spooled to the hard disk of the machine.
E210_NWG_US.book Page 8 Wednesday, August 18, 2004 3:40 PM
