Procedure
Detail & Action
Note
Time
Check the ITB
POS
Check iTB-POS & iTB-POS2
value; If not in range,
execute iTB Alignment Adj.
( See Service Manual )
1.
Execute
COPIER>FUNCTION>MISC-P>ITB-INIT
.
2.
See the
COPIER>DISPLAY>MISC>ITB-POS
.
3.
Repeat 1 and 2 for 3 times.
Point:
1. If the value of service mode is out of range,
perform the ITB Alignment Adjustment.
Note:
Since this product is not affected by the tilt
of the floor, adjustment of the adjuster height is
not valid. Therefore, if it is out of range, perform
“ITB adjustment”. ( See Service Manual)
Adjust
Adjust
5
min
Check
15
min
Adjust
5
min
Adjust
Perform Auto Correct
Color Mismatch/Auto
Adjust Gradation /
Auto Correct Color
Tone Setting
1.
Auto Correct Color Mismatch
Settings/Registration > Adjustment/Maintenance > Adjust Image
Quality•
>
> Auto Correct Color Mismatch
2. Auto Adjust Gradation ( Pick Paper Type & use Full Adjust)
Settings/Registration>Adjustment/Maintenance
>Adjust Image Quality•
> Auto Adjust Gradation
3.
Auto Correct Color Tone Settings
Settings/Registration>Adjustment/Maintenance
>Adjust Image Quality•
> Auto Correct Tone Settings
•
Point:
1. If error message shows up when performing
Auto Correct Color Mismatch, patch
registration shutter could be broken. Check
patch registration shutter .
2. If the customer use the heavy paper,
perform Auto Adjust Gradation with plain
and heavy paper.
3. If the machine has imagePASS P1, perform
calibration for imagePASS after performing
Auto Correct Color Mismatch/Auto Adjust
Gradation.
Check Finishing
devices
1.
If E540-8002, E542-8002,
110F, or 1104 is shown in
the error or jam list ensure
there are no boxes or waste
bin inhibiting the travel of
the trays up and down
movement.
2.
Ensure all paper clips and
staples are cleaned out of
the finishing device.
Point:
5
min
Check
C13
C14
Co
mm
on Process (
After
)
C12
iR ADV C5500 series Advance Maintenance Guide
Check
Check
