2
Preparing the Printer
Selecting a language displayed on the LCD
1111
Place the printer on a flat surface.
2222
Remove the shipping tape from the front
and back of the printer.
The tape position is subject to change.
3333
Open the card slot cover first and the
front cover next. Pull down and remove
the protective material on the right side.
4444
Close the front cover first and the card
slot cover next.
5555
Plug the power cord into the back of the
printer.
6666
Plug the power cord into the power
outlet.
7777
Turn on the printer.
The
POWER
lamp flashes and the printer begins to
operate. Wait until the
POWER
lamp remains fully lit.
8888
Select a language.
When the screen appears on the LCD;
• iP6220D
Use the
buttons to select a language and then
press the
OK
button.
• iP6210D
Use the
buttons to select a language and then
press the
OK
button.
Do not connect the USB cable at this stage.
If you leave the printer more than five minutes
without using any button on the operation panel,
the LCD goes into sleep mode automatically.
Press the
OK
button to turn on the LCD again.
6
.
5
.
7
.
ON
iP6220_6210D_QSG.fm Page 2 Tuesday, July 26, 2005 11:47 AM