Specifying Common Settings
4-38
4
C
u
s
to
m
iz
in
g S
e
tt
ing
s
Standard Paper for the Stack Bypass
You can set the paper size and type that the stack bypass uses beforehand. This setting is
useful if you always load the same paper size and type into the stack bypass.
If the Stack Bypass Standard Settings are stored when using the Send function, you can also
use the stack bypass to receive I-fax or fax documents.
IMPORTANT
When printing on special types of paper, such as heavyweight paper or transparencies, be sure to
correctly set the paper type, especially if you are using heavyweight paper. If the type of paper is not set
correctly, it could adversely affect the quality of the image. Moreover, the fixing unit may become dirty
and require a service repair, or the paper could jam.
NOTE
•
If you are using the stack bypass as a paper source for Copy and Receive (I-fax or fax), you must select
the stack bypass when specifying the Drawer Eligibility for APS/ADS setting. (See “Auto Paper
Selection/Auto Drawer Switching,” on p. 4-27.)
•
The default setting is ‘Off’.
1
Press
(Additional Functions)
➞
[Common Settings].
If necessary, see the screen shot in step 1 of “Initial Function at Power ON,” on p. 4-15.
2
Press [
▼
] or [
▲
] until [Stack Bypass Standard Settings] appears
➞
press [Stack Bypass Standard Settings].
Summary of Contents for iR2018i
