COPYRIGHT © 2001 CANON INC.
2000 2000 2000 2000
CANON iR2200/iR2800/iR3300 REV.0 MAR. 2001
CHAPTER 8 PAPER DECK-L1
8-32 P
4) Remove the compartment. (p. 8-25P)
5) Disconnect the connector [1], and re-
move the five screws [2]; then, detach
the deck lifter motor unit [3].
F08-303-04
3.3.5 Removing the Lifter Cable (deck front)
1) Sliding out the compartment. (p. 8-17P)
2) If paper is found, remove all of it.
3) Remove the screw [2], and detach the
paper trailing edge guide plate [1] from
inside the compartment. (The paper
trailing edge guide plate is not used if
the paper size is LTR.)
F08-303-05a
4) Push the sensor flag [1] of the paper
supply position sensor so the left/right
hole in the compartment side plate and
the left/right hole in the deck lifter will
match. (p. 8-20P)
(At this time, try to mach the top face of
the lifter against the marking [2] on the
left side plate of the compartment to fa-
cilitate the work.)
5) Fit two long screwdrivers [3] through to
keep the lifter in position.
F08-303-05b
[1]
[2]
[2]
[3]
[1]
[2]
[1]
[3]
[2]
Summary of Contents for iR2200 Series
