CHAPTER 4 SERVICE MODE
4-48
<CCD>
Making CCD- and Shading-Related Adjustments
If faulty images are noted after executing COPIER>FUNCTION>CCD>CCD-ADJ, enter
the settings indicated on the service label.
SH-TRGT
Use it to enter the white level target value for shading correction.
SH-RATIO
Use it to enter the data on the white label ratio (standard white paper and
standard white plate) for shading correction.
EGGN-ST
Use it to enter an adjustment value for the edge gain correction start posi-
tion for the CCD.
EGGN-END
Use it to enter an adjustment value for the edge gain correction end position
for the CCD.
<LASER>
Adjusting the Laser Output
If you have cleared the RAM on the DC controller PCB, be sure to enter the settings indi-
cated on the service label.
PVE-OFST
Use it to adjust the position of laser projection.
Range of
-300 to +300
adjustment
POWER
Use it to adjust the laser power for non-potential control.
Range of
0 to 255
adjustment
COPIER>ADJUST
Summary of Contents for IR5000 - iR B/W Laser
Page 72: ...CHAPTER 2 STANDARDS AND ADJUSTMENTS 2 52 Blank Page ...
Page 104: ......
Page 224: ......
Page 234: ......
