COPYRIGHT © 2001 CANON INC.
2000 2000 2000 2000
CANON iR5000i/iR6000i REV.0 JUNE 2001
CHAPTER 3 STANDARDS AND ADJUSTMENTS
3-22 T
5. Fixing System
5.1 Points to Note When Mounting the Fixing Heater
1) Do not touch the surface of the heater.
2) For both heaters, be sure that the side with the longer harness is toward the front.
3) Mount the main heater [1] to the right side and the sub heater [2] to the left side (view-
ing from the front of the fixing assembly).
4) Be user that the protrusions of the heaters will not interfere, i.e., stagger them.
5) When mounting the faston to the fixing heater at the rear, do not bend the faston termi-
nals (A, B) as if to direct it toward the outside.
Be sure it is parallel to the holder.
5.2 Position of the Fixing Inlet Guide
•
Points to Note When Making Adjustments in the Field
1) For the position of the inlet guide, see the instructions under 4.8, i.e., adjusting the posi-
tion of the fixing inlet guide solenoid (SL1).
2) The inlet guide will move down when the solenoid (SL1) turns on.
3) The difference in the height of the inlet guide between front and rear must be within 0.5
mm.
4) The height of the inlet guide may be adjusted by loosening the fixing screw on the
height adjusting support plate.
Removing the inlet guide base will require adjustment of the position of the
inlet guide. To avoid the adjustment, try not to loosen the mounting screw
on the inlet guide base. If you loosened it for some unavoidable reason, be
sure to position it correctly with reference to the index on the fixing assem-
bly base.
