COPYRIGHT © 2001 CANON INC.
2000 2000 2000 2000
CANON iR5000i/iR6000i REV.0 JUNE 2001
CHAPTER 5 SERVICE MODE
5-93 T
ACC
Use it to make accessories-related settings.
COIN
Use it to turn on/off the coin vendor indication.
•
The control card indicator used on the control panel may be used for the
coin vendor.
Settings
0: OFF (default), 1: ON (for count vendor)
DK-P
Use it to set a paper of the paper deck.
Caution
After electing the appropriate paper size, be sure to turn off and then on the
main power switch.
Settings
0: A4 (default), 1: B5, 2: LTR
INT-FACE
Use it to set conditions when a connection is made to an external controller.
IMG-CONT
Use it to recognize an external EFI controller.
Settings
0: external EFI controller absent (default)
1: external EFI controller prevent
TEMPO
Use it as an emergency remedy when the potential sensor or the environment sensor is
faulty (out of order).
F-POT-SW
Use it to turn on and off the setting if a transfer fault occurs because of a
fault (error) in the potential sensor.
•
Use it as an emergency remedy until the potential sensor is replaced.
Settings
0: OFF (default), 1: enables F-POT-D setting
F-POT-D
Use it if a transfer fault occurs because of a fault (error) in he potential sen-
sor.
•
It is valid only when F-POT-SW is set to '1'.
•
The level of separation current is in the order of 0>1>2.
Settings
0: for text-oriented users (originals with low image ratio)
1: for photo-oriented users (originals with high image ratio)
2: not used usually; however, if re-transfer (white spot at 50 mm
along leading edge) occurs
COPIER>OPTION
