7
User Guide
–
IRIScan
™
Desk 5 / Pro 5
3.3 Hardware installation
After installing the IRIScan
™
Desk software, you can install your
IRIScan
™
Desk scanner
. Double check the following procedure before
you proceed:
1.
Place the ScanPad on your desk next to your PC, and then place the IRIScan
™
Desk on the far end of the ScanPad (some marks are
drawn on the mat).
WARNING:
The dark color
ScanPad
is used to ensure a good image and accurate cropping of the targeted objects. Not using it
may give bad results.
2.
Connect the IRIScan
™
Desk scanner to your PC via a USB cable.
3.
Now you are ready to proceed to the next step for the software installation process.
If the device is not detected correctly, the detection keeps turning and a message is displayed on the screen to help you. See also
WARNING
: This software is distributed with a dedicated scanner: the
IRIScan
™
Desk
. This software can bring out its full and
powerful potentials only when working with the qualified scanner hardware. If working with non-qualified scanners, some or all
of the features in this software might NOT work.
3.3.1 Integrated lamp
IRIScan
™
Desk comes with an integrated lamp offering 3 luminous intensities.
It can be useful in case your scanning environement is quite dark.
To switch it on, simply touch the forefront of the scanner arm (
). Per default, the first luminous intensity is the strongest.
To change intensity, simply touch it again. At the fourth touch, the lamp switches off.
3.3.2 External capture button
(Pro 5)
A physical scan button can be plugged in the IRIScan
™
Desk scanner or directly in your PC thanks to the USB connector. It can replace
the scan button available in the ribbon of each tab in the software.