6-33
Optional Accessor
ies
6
Network Board
14
Install the network board.
15
Connect the interface cables except for the USB cable, and
connect the power cord.
16
Plug the power plug into the AC power outlet.
17
Connect the USB cable as needed, then close the expansion
slot cover.
Removing the Network Board
Remove the network board using the following procedure. Have ready the
protective plate and screws for the expansion slot removed when the network board
was installed.
CAUTION
•
Be sure to turn the printer and computer OFF and disconnect all the interface
cables and power cord from the printer before removing the network board. If a
USB cable is connected, turn the computer off, and then remove the USB cable.
If you attempt to remove the network board when the printer is ON or any cable
is connected to the printer, this may result in an electrical shock.
•
Be careful when handling the network board. Touching the edges or a sharp
portion of the network board may result in personal injury.
1
Open the expansion slot cover.
2
Turn the printer and computer OFF, remove the USB cable,
and then disconnect the power plug from the AC power outlet.
3
Remove all the interface cables and the power cord from the
printer.
4
Remove the two screws and remove the network board.
Store the network board in the protective bag that it came in.
Summary of Contents for laser Shot LBP 3300
