Photos
101
Additional Functions
Taking Photos in
y
Manual Mode
1 Set the mode switch to
y
.
2 Turn on the camcorder.
•
a
By default, photos are
recorded in the built-in memory.
You can select the memory that will
be used to record photos (
0
• Please read the IMPORTANT
section before using an Eye-Fi
card.
3 Touch [
3
] to switch to
mode.
4 Press
j
halfway.
Once the focus is automatically adjusted,
h
will turn green and one or
more AF frames will appear.
5 Press
j
fully.
The ACCESS indicator will flash as the photo is being recorded.
IMPORTANT
• Observe the following precautions while the ACCESS indicator is on or
flashing. Failing to do so may result in permanent data loss.
- Do not open the memory card slot cover.
- Do not disconnect the power source or turn off the camcorder.
- Do not change the camcorder’s operating mode.
• When recording photos on an Eye-Fi card, photos will be uploaded
automatically if you are within the range of a configured network. Always
verify that Eye-Fi cards have been approved in the country/region of
use. See also
Using an Eye-Fi card
(
0
Operating modes:
Summary of Contents for Legria HFM31
Page 1: ...PUB DIE 0363 000xc HD Camcorder Instruction Manual ...
Page 7: ...7 ...