9
Part Names and Functions
A built-in micro processor which controls this unit may occasionally
malfunction and need to be reset. This can be done by pressing the RESET
button with a pen, which will shut down and restart the unit. Do not use the
RESET function excessively.
Rear Terminal
IN
DVI - I /
RGB IN-1
RGB OUT
S-VIDEO IN
RGB IN-2
/
COMPONENT IN
/
COMPUTER
AUDIO
AUDIO IN
R
VIDEO IN
L
SERVICE PORT
RESET
MCI
AUDIO OUT
q
w
e
r
t
y
o
i
u
i
S-VIDEO IN
Connect the S-VIDEO output from video equipment to
this jack. (p18)
e
AUDIO IN
Connect the audio output from video equipment
connected to
r
or
i
to this jack. (When the audio
output is monaural, connect it to L (MONO) jack.) (p18)
y
COMPUTER AUDIO IN
Connect the audio output (stereo) from a computer or
video equipment connected to
q
or
o
to this jack.
(p 17, 19)
r
VIDEO IN
Connect the composite video output from video
equipment to VIDEO jack. (p18)
o
RGB IN-2/ COMPONENT IN/ RGB OUT
This terminal is switchable and can be used for input
from a computer, video equipment (Component or RGB
Scart) or output to the other monitor. Optional cables
are required when using this terminal as component
input or RGB Scart 21-Pin Video input. (p61)
Set the terminal up as either Computer input or Monitor
output properly. (Used for Monitor out, this terminal
outputs only incoming signal from DVI-I/ RGB IN-1
terminal.) (p17, 19, 44)
u
AUDIO OUT
Connect an external audio amplifier to this jack.
(p17- 19)
This terminal outputs sound from AUDIO IN terminal (
e
or
y
).
t
USB (Series B)
When operating the connected computer with the
remote control unit, connect USB port of your computer
to this connector with a USB cable. (p17)
w
SERVICE PORT
This jack is used to service this projector.
✽
Pa
rt
Names and Functions
✽
Do not press this button. This button is used for optional
accessories.
q
DVI-I/ RGB IN-1
Connect output signal from a computer (Digital/Analog
DVI-I type) or Multi Card Imager (optional) to this
terminal. (p17)
