Key to Enjoying Consistent Printing Quality
The key to printing with the optimal printing quality is to prevent the print head from drying
or clogging. Always observe the following rules for optimal printing quality.
Never disconnect the power plug until the power is turned off!
If you press the
ON
button to turn off the power, the machine caps the print head (nozzles)
automatically to prevent from drying. If you disconnect the power plug from the wall outlet
before the power is turned off (while the
ON
lamp is lit or flashing), the print head will not be
capped properly and this will cause drying or clogging.
When disconnecting the power plug, make sure that the
ON
lamp is not lit.
Notice for Unplugging the Power Cord
Print periodically!
Just as the tip of a felt pen becomes dry and unusable if it has not been used for a long
time, even if it is capped, the print head too, may become dried or clogged if the machine
has not been used for a long time.
We recommend you to use the machine at least once a month.
Note
Depending on the type of paper, ink may blur if you trace the printed area with a
highlight pen or paint-stick, or bleed if water or sweat comes in contact with the printed
area.
120
Summary of Contents for MG 2520
