Operation Panel
* All lamps on the operation panel are shown lit in the illustration below for explanatory
purposes.
(1)
ON button
Turns the power on or off. Before turning on the power, make sure that the
document cover is closed.
Turning the Machine On and Off
(2)
ON lamp
Lights green after flashing when the power is turned on.
Note
ON and Alarm lamps
You can check the status of the machine by the
ON
and
Alarm
lamps.
–
ON
lamp is off: The power is off.
–
ON
lamp lights green: The machine is ready to print.
–
ON
lamp flashes green: The machine is getting ready to print, or printing is in
progress.
–
Alarm
lamp flashes orange: An error has occurred and the machine is not ready
to print.
"Support Code Corresponding to the Number of Flashes of the Alarm Lamp" in If
an Error Occurs
–
ON
lamp flashes green and
Alarm
lamp flashes orange alternately: An error that
requires contacting the service center may have occurred.
"Support Code Corresponding to the Number of Alternate Flashes of the ON
Lamp and the Alarm Lamp" in If an Error Occurs
(3)
Alarm lamp
27
Summary of Contents for MG 2520
