Continued on the following page >>
2.Edit Exposure Mode Settings
– 11 –
4
Set the DEP EFFECT parameter of the High-Density Field
Touch the
or
button, and set the value within the range between 0 to 10.
The value on the left is the setting saved previously, and the value on the right is the cur-
rent setting.
The value indicates the intensity of restoration in high frequency component that reflects
the starting density and compression ratio of the High-Density Field.
Select a larger value for higher degree of intensity, and select a smaller value for lower
degree of intensity.
NOTE:
If the DEP EFFECT parameter is set to an excessive value, artifacts may
occur in the image, or the effective data of the exposure image may be dam-
aged.
Check the exposure image, and if the results of compression appear to be too
strong, either set the parameter to a smaller value, or set the DWT DEP not
effective.
2.3.2 Setting DWT DEP for Low-Density Field
1
Set the DWT DEP for the Low-Density Field effective
Touch
[LOW DENS.]
to display the parameters. The appearance of the button switches
over between the highlight (in white outline characters against a colored background)
and normal display each time you touch the button. The parameters are available when
the button is displayed in highlight.
DWT DEP Screen with Parameters of HIGH and LOW DENS.
