![background image](http://html2.mh-extra.com/html/canon/multipass-f20/multipass-f20_basic-manual_4681292028.webp)
3-10
Print media handling
Chapter 3
Loading banner paper
NOTE
• Always leave an extra sheet at the end of the banner—just in case the type runs over.
• Printing on banner paper may require considerable amounts of ink so use new ink tanks if necessary.
• For best print results on banner paper, use light design patterns.
Follow this procedure to load banner paper in the multi-purpose tray:
1
Make sure the paper thickness lever is
set to the right.
• For details, see p. 3-6.
2
Lower the tray extension on the multi-
purpose tray.
3
Cut the banner paper to the required
length and place it behind the machine
on a flat surface. Then insert the first
sheet in the multi-purpose tray
q
and
adjust the paper guide
A
to the width
of the sheet leaving an
! / 8
inch (1 mm) gap
between the paper guide and edge of
the sheet
w
.
• Make sure the sheets behind the machine are
aligned with the first sheet.
4
Set your computer to print on banner
paper.
• Allow the paper to flow over the edge of the
table as it exits the machine.
w
q
A
Summary of Contents for MultiPASS F20
