10-22
Troubleshooting
Chapter 10
MP L6000—USERS MANUAL/V000/12-97
Problem
Cause
Solution
The MultiPASS does
The MultiPASS may not
For the MultiPASS to switch
not switch automatically
be in FaxTel mode.
automatically between fax
between telephone and
and telephone reception, the
fax transmissions
Receive Mode must be set to
FaxTel mode.
In the Advanced: Receive Fax
Make sure this option is set
options, the “Default Action
to Receive. (See page 8-8).
if No Answer To Telephone”
is set to Disconnect.
There may be a document
Make sure you have printed
in memory.
out any documents in memory.
An error may have occured
Check the LCD for an error
during reception.
message. (See page 10-11.)
The multi-purpose tray may
Make sure paper is loaded in
be empty.
the multi-purpose tray.
The sending fax may not
Some fax units cannot send
send the CNG signal that
the CNG signal that tells your
tells the MultiPASS that the
MultiPASS the incoming signal
incoming signal is a fax.
is from a fax. In such cases,
you will have to receive the
document manually.
Cannot receive a
You may have pressed
Always press
START/COPY
document manually
START/COPY
after hanging
before hanging up the
up the telephone.
telephone. Do not press
START/COPY
after you hang
up the telephone; this will
disconnect the call.
Summary of Contents for MultiPASS L6000
