Chapter 8
MultiPASS Printer Setup and Other Utilities in the Desktop Manager 8-13
MultiP
ASS Printer
Setup and Other
Utilities
❏
Listen Time Before Ringing
When a call is received, the MultiPASS printer checks to see if the call
is from a fax machine or a telephone. If the MultiPASS printer does
not have enough time to detect the fax tone, it assumes the call is
from a telephone. You use this option to set the appropriate amount
of time to allow the MultiPASS printer to check for the type of call.
❏
Ring Time
When your MultiPASS printer is set to receive both fax and telephone
calls, it rings to inform you of an incoming telephone call. If you do
not pick up the handset within a certain amount of time, the
MultiPASS printer stops ringing. You use this option to set the
appropriate amount of time the MultiPASS printer should ring.
❏
Ring Tone
You can set the volume level of the ring tone.
❏
Default Action If No Answer to Telephone
You set this option to Receive if you want the MultiPASS printer to
handle an incoming call, detected as a telephone call that is not
answered, as an incoming fax. If no fax is received, the line is then
disconnected. If you set this option to Disconnect, the MultiPASS
printer automatically disconnects the unanswered call, without
switching to try and receive a fax.
❏
Manual/Auto Switch (Europe only)
To prevent missing incoming documents when the MultiPASS printer
is set to manual receiving, you can set the unit to automatically
answer the phone and switch to automatic. The unit can receive the
incoming fax after the specified ring time (the number of seconds you
specify).
❏
Answering Machine Mode Options
You use this option only if: you set the receive mode on the Receive
Fax tab to answering machine mode, and your fax sender may be
using a fax machine that does not emit a send fax signal.
Select this option to have the MultiPASS printer automatically
receive a call as a fax call if a send fax signal is not detected for the
number of seconds you specify.
