Nagel Finisher Service Support Guide
Nagel Finisher Service Support Guide
Rev. 0
September 2001
Page 5
V. Service
Features
A. Serviceability
To ensure machine reliability, Canon U.S.A., Inc. recommends that a
Quality Assurance Visit is performed to clean and inspect the Nagel
Finisher when performing QA for the CLC 5000. Refer to the CLC 5000 for
further details.
B. Software
Requirements
The CLC 5000 should be Version 4.03 or higher; the ColorPASS-Z5000
should be V1.2 or higher, and DocBuilder Pro™ requires use of a Dongle
at the workstation used.
C. Estimated Installation Time
The installation time will vary based upon system configurations.
Description
Estimated Time
5
Nagel Booklet Maker/FN5
(With Buffer Pass)
40 minutes
Nagel Trimmer/TP5 (Option)
30 minutes
Shift Tray (Option)
20 minutes
D. Space
Requirements
This section specifies the minimum amount of space required for the
system. The area where the system is to be located should provide easy
access to all sides of the equipment for service, allowing at least one foot
on either side and at least one foot in the rear.
NOTE:
Due to the weight of the Nagel Finisher, it is recommended that at
least four people be used to lift each section off the palate.
5
Estimated installation times are based on hardware installation with an experienced technician only.
