3. Mounting the Transfer Corona Unit
1)
that the wire cleaning mount at the
home position.
3)
Wire cleaning mount
Figure 4-71
2) Movethewirecleanerofthetransfercoronaunit
by hand to the front.
3) Slidethetransfercoronaunit intothecopier, and
check that the pins of the wire cleaner are inside
the wire cleaner unit.
4)
Mount the transfer corona unit
If the wire cleaner mount not at the home
position. perform the following:
The wire cleaner mount stops where it as soon
as the
turned OFF during cleaning
operation;
cases, work as follows:
Movethewirecleanerofthetransfercoronaunit
by hand to the rear as far as it goes.
Mount the transfer corona
withthefeederunit released.
and check that the wire cleane returns to the
home position.
Note:
The step given
for when the cleaning
motor good condition; if the motor not
good condition or if the wire cleaner mount
faifstoreturnto the
becauseof
displaced screws, the COPY START key
the control panel remains red. As
if the
key remains red after the wait period, check
the cleaning motor.
4 - 2 4
CANON
CANON
MAY
IN JAPAN
Summary of Contents for NP-2020
Page 5: ......
Page 171: ...LL w I n t 0 m a 9zcr 9zcr ...
Page 172: ...I I i I am w m h I I r l I I B m 0 4 u I m ll ...
