3-11
Special Features
Specify the width of the margin [0" -
3
/
4
"
(0
~
20 mm)], then press the [OK] key.
Use the [+] and [–] keys to set the width of the
margin.
• Press the [+] key to increase the size of the
margin.
• Press the [–] key to decrease the size of the
margin.
• Press the [mm] key to enter in millimeters.
MEMO:
●
The default setting for the margin width is
3
⁄
8
" (10 mm).
●
You can create a margin for front and back sides of
the copy in one step.
●
If you are using the Margin and Two-sided modes
together and copying an original that already has a
margin, then follow the instructions listed below
depending on the two-sided copying feature which
you have set.
1
→
1-sided:
You do not need to set the margin.
Proceed to copy in the usual way.
1
→
2-sided:
Set the margin for the back only. Set
the margin for the front to 0" (0 mm).
2
→
2-sided:
You do not need to set the margin.
Proceed to copy in the usual way.
2
→
1-sided:
Set the margin for the back only. Set
the margin for the front to 0" (0 mm).
●
Using the “Inch Entry” in the Additional Functions
mode, you can set the copier so that entry can only
be done in millimeters.
In this case the [INCH] key is not displayed.
After you have finished making the settings,
press the [DONE] key.
3
Proceed to copy in the usual manner.
(See “Making Copies,” on p. 2-4.)
MEMO:
●
To cancel the settings, press the [SPECIAL
FEATURES], [MARGIN], and [C] keys in that order.
●
You can also cancel the mode by pressing the
Reset
key. (The copier returns to the Standard mode.)
