![background image](http://html.mh-extra.com/html/canon/oce-blm550/oce-blm550_operation-manual_58070072.webp)
¦
¦
V
No further action is required.
Call your service engineer.
Trimming problem - the book is not trimmed square
Open the trim stop guard and check for paper trimmings (see
Clear paper from the trim stop on
Is the trim stop clear of paper trimmings?
Yes
No
¦
¦
¦
¦
¦
¦
V
Clear paper from the trim stop.
Does the problem persist?
Yes
No
¦
¦
V
No further action is needed.
Call your service engineer.
Trimming problem - poor trim quality
The trim process uses a double-edge blade to cut thick books. This can leave a small mark in the
center of the trimmed edge. The visibility of this mark will depend on the paper quality and
characteristics.
[26] Blade witness mark in the center of the book
[27] Blade damage mark
Are there marks on the trimmed edge other than the blade witness mark?
4
Book Quality
72
Chapter 6 - Error Conditions, Problems and Solutions
Summary of Contents for Oce BLM550+
