90
E
Using the Full
Range of Features
Returning to a Pre-Marked Position
Use the wireless controller to mark a point on a tape that you want to return
to following playback.
1. Press the ZERO SET MEMORY button on the wireless
controller during playback at a point you want to return to
later.
• The time code is replaced by a tape counter that is set to zero with the
Â
indication.
• Press the ZERO SET MEMORY button once more to cancel the zero set
memory.
2. When you have finished playback, fast forward or rewind
the tape. The tape stops automatically when it reaches the
zero set position.
•
RTN
1
or
`
RTN
appears in the display.
• The tape counter with
Â
indication disappears from the display and the
time code reappears.
Notes:
• The zero set memory may not function correctly where there is a break
between recordings on the tape.
• You can also use zero set memory to mark a position on a tape in TAPE
CAMERA mode. When you then play back the tape, pressing rewind will
take you back to the pre-marked position.
• If you remove the tape while the zero set memory is set, the memory is
canceled and the tape counter reverts to time code.
• The camcorder remembers your setting even if you turn it off and back on
again or move the program selector.
(VCR)
PL
A
Y
CA
ME
RA
OF
F
/
/
REW
PLAY
FF
ZERO SET
MEMORY
AUDIO DUB.
STOP
PAUSE
SLOW
×
2
+
/
–
/
REC
PAUSE
+
,
+
PLAY
(VCR)
TAPE
CAMERA
TAPE
