6. Gently lift the power supply out of the chassis.
1
Figure 21: Removing the power supply
No.
Name
1
Screw (1 of 4)
● Replace the power supply
1. If you are replacing the power switch, locate the new power switch included with the replacement power supply kit.
Orient the power switch as shown in Figure 21.
2. Place the power supply inside the chassis (see Figure 21).
Make sure to fit the power connector through the cutout in the chassis. Align the mounting holes in the power supply with
the holes in the chassis.
3. Using the four screws that you removed earlier, secure the power supply to the chassis.
4. Connect the 4-pin (2x2) power cable to the 4-pin connector on the motherboard.
For the location of the motherboard connector (see
“Motherboard parts and connectors” on page 26
). Connect the power
cable to pins 1 through 4 of the motherboard connector. The cable is keyed to fit only one way.
5. Make sure that all power connectors are properly aligned and securely connected.
6. Secure the power cables to the chassis using the two plastic clips on the base of the chassis.
7. Replace any tie-wraps that you may have removed or cut while removing the power cables earlier.
8. Reassemble the
imagePRESS Server
and verify its functionality (see
“Reinstall and verify the imagePRESS Server”
■ Storage Device
The factory-installed hard disk drive (HDD) is formatted and loaded with system software, network drivers, and printer fonts. The
storage device is used to store spooled print jobs.
Available space on the storage device is displayed in Command WorkStation.
If you replace the storage device, you must install the system software on the new storage device.
Replacement storage device are not shipped with preinstalled software.
Do not replace the HDD and the motherboard at the same time.
Doing so in the wrong order, without updating the system, will cause the system to malfunction.
3. REPLACING PARTS
39
Summary of Contents for P 400
Page 7: ...Introduction 1 Introduction 2 Specifications 7...
Page 16: ...Using the imagePRESS Server 2 Using the imagePRESS Server 11...
Page 21: ...REPLACING PARTS 3 Replacing parts 16...
Page 51: ...INSTALLING SYSTEM SOFTWARE 4 Installing system software 46...