Replacing parts
Replacement parts and specifications are subject to change.
Generally, the
imagePRESS Server
requires no regular service or maintenance. Use the procedures in this chapter to inspect,
remove, reseat, and replace major hardware components.
Overview
This chapter includes information about servicing the following components:
• Boards and cables
• Motherboard components (DIMMs, CPUs, battery)
• Fan
• Power supply
• Storage device
Replacement parts are available from your authorized service/support center. The terms “replace” and “replacing” are typically
used throughout this document to refer to the re-installation of existing components.
Install new components only when necessary. If you determine that a component you removed is not faulty, reinstall it.
NOTE:
Replacement parts and specifications are subject to change. Install the correct parts as directed by your service/support center.
IMPORTANT:
When servicing the
imagePRESS Server
, follow the precautions listed in Precautions on
.
For a list of the tools required to service the
imagePRESS Server
“Tools you will need” on page 3
.
■ imagePRESS Server hardware
This section provides illustrations for the
imagePRESS Server
.
1
6
7
4
5
3
2
8
Figure 2:
imagePRESS Server
connector panel
No.
Item
1
Network port (connected to the network)
2
USB3.0 port (x2)
3
Crossover Ethernet port (connected to the printer)
3. REPLACING PARTS
16
Summary of Contents for P 400
Page 7: ...Introduction 1 Introduction 2 Specifications 7...
Page 16: ...Using the imagePRESS Server 2 Using the imagePRESS Server 11...
Page 21: ...REPLACING PARTS 3 Replacing parts 16...
Page 51: ...INSTALLING SYSTEM SOFTWARE 4 Installing system software 46...
