IMPORTANT:
The IMPORTANT indicates operational requirements and restrictions. To operate the
imagePRESS Server
correctly and
avoid damage to the
imagePRESS Server
or other property, always pay attention to IMPORTANT letter and messages.
How the imagePRESS Server operates
When a customer prints, the motherboard and printer interface board process image data. The printer interface board is a custom
board and allows the
imagePRESS Server
to communicate with the printer. The CPU controls the transfer of image data to and
from the motherboard and runs the PostScript interpreter. DIMM holds image data during printing.
Using compression technology, the interpreter rasterizes the page description file and compresses the image pattern into memory.
The interpreter outputs the compressed raster data through the image frame buffer memory to the printer interface board. The
raster data is sent to the printer, which then renders the image on paper at maximum speed.
Before you service the imagePRESS Server
Before you service the
imagePRESS Server
, it is strongly recommended that you make sure that you have the required tools
“Tools you will need” on page 3
) and carefully review all precautions (see
Also, keep in mind that the most common cause of a hardware problem is a faulty or loose connection. Before you replace an
expensive component, check internal and external connections.
Tools you will need
To install or service the
imagePRESS Server
, you will need the following tools and parts:
• ESD wrist grounding strap and antistatic mat
• Flathead screwdriver
• #0, #1, and #2 Phillips head screwdrivers
• Needlenose pliers
•
imagePRESS Server
documentation, including the customer media pack and any related service bulletins
IMPORTANT:
Avoid touching magnetic tools to storage device such as hard disk drives. Contact between magnetic tools and magnetic
storage device may result in data corruption.
Precautions
This section includes information about how to safely operate and service the
imagePRESS Server
and how to avoid
damage to
imagePRESS Server
components.
Notices on installation location
WARNING:
The imagePRESS Server is not suitable for use in locations where children are likely to be present.
Report shipping damage
If there is evidence of shipping damage, save the shipping boxes and damaged parts. Call the shipper immediately to file a claim
and notify your authorized service/support center.
Do not change an existing network
The
imagePRESS Server
is probably connected to an existing Local Area Network (LAN) based on Ethernet hardware.
The network is the link between the customer’s computer, existing laser printers, and other prepress equipment. Never disturb
the LAN by breaking or making a network connection, altering termination, installing or removing networking hardware or software,
or shutting down networked devices without the knowledge and express permission of the site administrator.
1. Introduction
3
Summary of Contents for P 400
Page 7: ...Introduction 1 Introduction 2 Specifications 7...
Page 16: ...Using the imagePRESS Server 2 Using the imagePRESS Server 11...
Page 21: ...REPLACING PARTS 3 Replacing parts 16...
Page 51: ...INSTALLING SYSTEM SOFTWARE 4 Installing system software 46...