Canon Paper Craft Castel Sant'Angelo Italy, Assembly Instructions Manual

http://www.canon.com/c-park/en/

Assembly Instructions

Mountain fold(dotted line)

Make a mountain fold.

Valley fold(dashed and dotted line)

Make a valley fold.

Scissors line(solid line)

Cut along the line.

Cut in line(solid line)

Cut along the line.

Glue spot(Red dot)

Glue parts with the same number together.

Glue spot(Green dot)

Glue within the same part.

Glue spot(Blue dot)

Glue to the rear of the other part.

Glue

The glue spot(colored dot)

shows where to apply the glue.

Tools and materials

Assembly tip

Caution

Scissors, set square, glue(We recommend stick glue), pencil, used

ballpoint pen, toothpicks, tweezers, (useful for handling small parts)

Before gluing, crease the paper along mountain fold and valley 

fold lines and make sure rounded sections are nice and stiff.

Glue, scissors and other tools may be dangerous to young children 

so be sure to keep them out of the reach of young children.

View of completed model

Assembly Instructions : Eleven A4 sheets (No. 1 to No. 11)

*Hint: Trace along the folds with a ruler

  and an exhausted pen (no ink) to get a sharper, easier fold.

* Build the model by carefully reading the Assembly Instructions , in the parts sheet page order.

* This model was designed for Papercraft and may differ from the original in some respects.

Before starting assembly : 

Writing the number of each section on its back side before 

cutting out the sections is highly recommended.

(* This way, you can be sure which section is which even after 

cutting out the sections.)

Indicates where sections should 

be glued together.

Glue the rear sides together.

Glue the rear sides together.

Castel Sant'Angelo, Italy : Assembly Instructions

©

 Canon Inc. 

©

T. Ichiyama