1
Canon
®
is a registered trademark of Canon Inc.
©
Canon Inc.
©
Y. Watanabe
http://www.canon.com/c-park/en/
Rainbow beetle: Assembly Instructions
4
5
6
Assembly Instructions
Mountain fold(dotted line)
Make a mountain fold.
Valley fold(dashed and dotted line)
Make a valley fold.
Scissors line(solid line)
Cut along the line.
Cut in line(solid line)
Cut along the line.
Glue spot(Red dot)
Glue parts with the same number together.
Glue spot(Green dot)
Glue within the same part.
Glue spot(Blue dot)
Glue to the rear of the other part.
Tools and materials
Assembly tip
Caution
Scissors, set square, glue(We recommend stick glue), pencil, used
ballpoint pen, toothpicks, tweezers, (useful for handling small parts)
Before gluing, crease the paper along mountain fold and valley
fold lines and make sure rounded sections are nice and stiff.
Glue, scissors and other tools may be dangerous to young children
so be sure to keep them out of the reach of young children.
View of completed model
Assembly Instructions:Three A4 sheets(No.1 to No.3)
*Hint: Trace along the folds with a ruler
and an exhausted pen (no ink) to get a sharper, easier fold.
*Build the model by carefully reading the Assembly Instructions, in the parts sheet page order.
*This model was designed for Papercraft and may differ from the original in some respects.
Assemble Parts 7-9
in the same manner.
Do not glue
this area.
Do not glue
this area.
Assemble Parts 19-21
in the same manner.
Assemble Parts 31-33 in
the same manner.
Assemble Parts 10-12
in the same manner.
Assemble Parts 22-24
in the same manner.
Assemble Parts 34-36
in the same manner.
Glue
The glue spot(colored dot)
shows where to apply the glue.
Before
starting
assembly:Writing the number of each section on its back side
before cutting out the sections is highly recommended. (* This way, you can
be sure which section is which even after cutting out the sections.)
Indicates where sections
should be glued together.
