1
2
3
5
6
7
8
4
1
http://www.canon.com/c-park/en/
View of completed model
Assembly Instructions: Six A4 sheets (No.1 to No.6)
*Hint: Trace along the folds with a ruler
and an exhausted pen (no ink) to get a sharper, easier fold.
*Build the model by carefully reading the Assembly Instructions, in the parts sheet page order.
Before starting assembly:Writing the number of each section on its back side before
cutting out the sections is highly recommended.
(* This way, you can be sure which section is which even after cutting out the sections.)
Indicates where sections
should be glued together.
Sydn
ey Oper
a House
Sy
dney, A
ustral
ia
Sydney Opera House (Australia): Assembly Instructions
Canon
®
is a registered trademark of Canon Inc.
©
Canon Inc.
©
A & A Co., Ltd.
*This model was designed for Papercraft and may differ from the original in some respects.
(1) Build the base.
Insert.
Assembly Instructions
Mountain fold(dotted line)
Make a mountain fold.
Valley fold(dashed and dotted line)
Make a valley fold.
Scissors line(solid line)
Cut along the line.
Cut in line(solid line)
Cut along the line.
Glue spot(Red dot)
Glue parts with the same number together.
Glue spot(Green dot)
Glue within the same part.
Glue spot(Blue dot)
Glue to the rear of the other part.
Glue
The glue spot(colored dot)
shows where to apply the glue.
Tools and materials
Assembly tip
Caution
Scissors, set square, glue(We recommend stick glue), pencil, used
ballpoint pen, toothpicks, tweezers, (useful for handling small parts)
Before gluing, crease the paper along mountain fold and valley
fold lines and make sure rounded sections are nice and stiff.
Glue, scissors and other tools may be dangerous to young children
so be sure to keep them out of the reach of young children.
