<Button and LCD viewer test>
After moving to the button and LCD viewer test mode, perform the following to check the operation of buttons and the LCD viewer display.
1) Press the Paper Feed switch. The LCD viewer's color will change and display “blue” full-screen. (If an error has occurred, the error LED lights. In this case,
input other than the Power button is not possible. Re-enter service mode to perform this test.)
2) Press each button on the operation panel (excluding the Power and Resume buttons). Each time each button is pressed, a part of the display will change to
“red”. (The area changed to "red" is as shown in the diagram below. The figure shows the display when both the Menu and OK buttons are pressed.)
===LCD viewer display===
3) Press all buttons, excluding the Power button and Resume button. The entire LCD viewer will change to display “red” full-screen.
4) Open the cover to display the color pattern.
5) Press the Power button to return to the service mode function selection status.
To the top
<Part 1: 3. REPAIR, 3-3 (4) to (7)>
1 - 15
Summary of Contents for PIXMA iP6000D
Page 7: ...Part 1 MAINTENANCE ...
Page 17: ... 3 Grease application 1 10 ...
Page 27: ...Part 2 TECHNICAL REFERENCE ...