Carefully remove all items from the box.
1
Remove the shipping tape from the front
and back of the printer.
1
Remove the print head from its package.
1
Peel back the orange tab and completely
remove the plastic wrapper from the
Magenta Ink Tank (BCI-6M).
1
TURN THE PRINTER OFF.
1
Connect one end of the USB cable
to the computer, the other to the printer.
2
Remove the shipping tape from the paper
guide. Pinch the paper guide and slide it to
the left. Load a few sheets of blank paper
into the sheet feeder, then slide the paper
guide toward the left edge of the paper.
3
Remove the orange protective cap from
the print head.
2
Raise the print head lock lever.
3
Plug the power cord into the back of the
printer and connect the other end to a
power outlet. Press the POWER button.
The printer will initialize.
2
Lower the paper output tray. Raise the
cover.
Lower the inner cover.
3
The print head holder automatically moves
to the center. Remove the protective tape.
4
Write down the serial number located to
the right of the print head holder . You will
need this later to register the product.
5
1
Unpack the Printer
2
Prepare the Printer
3
Install the Print Head
4
Install the Ink Tanks
Connect the Printer
5
and Load Paper
PIXMA iP6000D Series
Photo Printer
Documentation
and Software Kit
PIXMA iP6000D Series
Print Head
Power Cord
Ink Tanks
BCI-6PC PhotoCyan
BCI-6C Cyan
BCI-6BK Black
NOTE:
Do not touch the print head nozzles
and the electrical contacts.
Twist off and discard the orange protective cap.
2
NOTE:
To avoid spilling ink, never press on
the sides of an ink tank.
NOTE:
The printer will perform a print head
cleaning. Wait until the POWER lamp displays
a steady green light before proceeding.
IMPORTANT:
Be sure to close the inner
cover completely, or the paper will not
feed properly.
Ink Tanks
BCI-6Y Yellow
BCI-6PM PhotoMagenta
BCI-6M Magenta
Start Here
Easy Setup Instructions
Series
Photo Printer
Inner Cover
Cover
Paper Output Tray
Protective Tape
Serial Number
Location
Insert the ink tank into the correct slot.
(Refer to the color guide on the print head lock
lever).
Press down until the ink tank clicks into place.
3
Insert the remaining five ink tanks into
their assigned slots.
4
Close (a) the inner cover, and then (b) the cover.
Lift open the paper support .
5
Extend the paper support and paper output tray
extension.
6
Slide the print head into the holder.
The print head will rest at a slight angle.
4
Lower the print head lock lever and press
it down until it clicks into place.
5
Tear at notch to open
Print Head Nozzles
Electrical Contacts
Protective Cap
click
click
Paper Support
(a) Inner Cover
Paper Output Tray Extension
(b) Cover
IMPORTANT:
Be sure the printer is off
before continuing, or the computer will
attempt to install the printer driver before
the printer is ready.
IMPORTANT:
Print Head Alignment (Step 6)
requires that 8.5"x11" paper is loaded in
the sheet feeder (top paper feeder).
USB Cable
USB Port
Continue with Step 6
on side two.
Sheet Feeder
Paper
Guide
USB Cable
USB Port
POWER
Button
POWER
Lamp
