(11) Ink absorber replacement
If the ink absorber alone needs to be replaced (because the ink absorber becomes full, etc.) and no other engine
parts are replaced, the ink absorber can be replaced only by separating the print unit from the bottom case. It is not
necessary to disassemble the whole engine unit.
1) Disconnect the DC harness ass'y from the logic board connectors.
2) Remove a total of 8 screws:
- 3 screws fixing the switch system unit to the bottom case
- 3 screws fixing the purge drive system unit to the bottom case
- 1 screw fixing the PictBridge chassis to the bottom case
- 1 screw fixing the ground harness ass'y to the front chassis
Specific screw location:
38 / 62
Summary of Contents for PIXMA MG5220 Series
