16. Adjust tilt with the 2 adjusters until a top gap [1] and
a bottom gap [2] between the POD Deck Lite and the
host machine are same width.
• Rotate to [A] direction: Ascent
• Rotate to [B] direction: Descent
[1]
[2]
[A]
[B]
CAUTION:
• In case that the gap between the top [1] and the
bottom [2] is not in parallel, connection may not be
detected.
• Allowance gap range is that the bottom [2] is 2mm
shorter than the top [1].
• When relocating the POD Deck Lite, re-adjust the
gap in parallel.
2mm
[1]
[2]
17. Attach the wire saddle to the hole on rear side of the
POD Deck Lite and then clamp the cable with it.
• 1 Wire saddle
1x
18. Connect the lattice connector with the host machine.
1x
19. Connect the power cord to the inlet of the POD Deck
Lite and then plug it to the external source.
CAUTION:
Make sure that the power cord is fully connected to the
outlet. If the connection is incomplete, smoke or fire
may occur.
6. Installation
116
Summary of Contents for POD Deck Lite-C1
