Controls
Overview
Item
Reference
1. Pickup/Feed System
Pickup/feed control
“Pickup/Feed Control” on page 15
Paper presence/absence detection control
“Paper Presence/Absence Detection Control” on page
16
Paper surface detection control
“Paper Surface Detection Control” on page 16
2. Compartment system
Lifter control
Remaining paper level detection control
“Remaining Paper Level Detection Control” on page 17
Switching the paper size
“Switching the Paper Size” on page 18
Compartment open/close control
“Compartment Open/Close Control” on page 19
Air assist control
“Air Assist Control” on page 20
Swing operation
3. Deck control system
Cassette heater control (option)
“Cassette Heater Control (Option) ” on page 22
Power supply
4. Others
Fan control
Jam detection
Pickup/Feed Control
The paper deposited in the compartment is held up by the work of the lifter, and is kept to a specific level.When the start key on
the host machine is pressed, and the drive of the deck pickup motor (M1) starts to rotate the pickup roller to pick up paper. At
this time, the deck feed roller and the deck separation roller operate to make sure that only a single sheet of paper is picked up
and moved. When the deck pull-out sensor (SR6) detects paper at the time of heavy paper (151 g/m2 or more) and transparency
setting, the deck pickup release solenoid (SL2) goes on to move the deck pickup roller away from the stack of paper. The deck
pull-out roller starts to rotate when the deck pull-out motor (M2) goes on. After pickup, the paper is moved as far as the registration
roller of the host machine.
M2
SL2
M1
Deck pull-out
roller
Deck separation roller
SR6
Deck feed roller
Deck pickup roller
NOTE:
Service Mode
• Setting of Deck Pickup Roller eng/diseng
To set whether to disengage the Pickup Roller of the POD Deck Lite every time paper is picked up.
Lv2) COPIER > OPTION > FEED-SW > DK1-PSP
< Setting value >
0 to 1
• 0: Disengaged only for heavy paper (151 g/m2 or more) and transparency
• 1: Disengaged regardless of paper type
< Use case >
• When Pickup Roller trace occurs on the 2nd sheets and later
< Caution >
• If the machine is continued to be used while the setting value is 1, the life of the solenoid becomes shorter.
2. Technology
15
Summary of Contents for POD Deck Lite-C1
