COPYRIGHT © 2001 CANON INC.
2000 2000 2000 2000
CANON SmartBase PC1200s/iR1200s REV. 0 DEC. 2001
CHAPTER 7 TROUBLESHOOTING
7-8
1.3 Making Adjustments (ADF)
1.3.1 Items of Adjustment and Sequence of Work
The ADF must be adjusted for the following items and in the following sequence of work:
1. If you have replaced major parts of the ADF, you must always execute
the following: registration arch auto adjustment, original read position
adjustment. Then, check to make sure that the settings of other items of
adjustment are as indicated; if not, make adjustments starting with the
preceding item of adjustment.
2. Each item of adjustment affects the subsequent items of adjustment. If
you have made adjustments, therefore, be sure to check that the setting
of the item of adjustment that follows is also as indicated; if not, be sure
to start over with the preceding item.
1.3.2 Preparing a Test Sheet for Adjustment
When making adjustments (except registration arch auto adjustment and original read po-
sition adjustment) for the ADF, you will need a test sheet like the one used for the copier.
Prepare a test sheet by referring to the instructions given under 1.2.2 of Chapter 7.
Sequence
1
2
3
4
5
6
7
Item of adjustment
registration arch auto adjustment
skew removal
original read position adjustment
original feed speed adjustment
leading edge read start position adjustment
trailing edge read end position adjustment
left/right registration adjustment
