CHAPTER 2 USING THE MACHINE
COPYRIGHT © 2001 CANON INC.
2000 2000 2000 2000
CANON SmartBase PC1200s/iR1200s REV. 0 DEC. 2001
2-32
#SSSW-SW02:
network connection conditions setting
Bit
0
1
2
3
4
5
6
7
Function
start-up at memory clear list out-
put fault
not used
not used
not used
not used
not used
not used
not used
1
prohibit
-
-
-
-
-
-
-
0
do not prohibit
-
-
-
-
-
-
-
Factory setting
0
[Bit 0]
Use it to specify whether or not to put the machine in standby state if the memory clear
list is not generated when the power is turned on after an error has occurred (e.g., running
out of paper).
If set to ‘1’, the machine will generate a memory clear list and enters standby state when
the image data is cleared and the power is turned on.
If set to ‘1’, moreover, the following takes place:
1. The alarm sounds, and the machine waits for correction; specifically,
a. The LCD indicates ‘CHECK PRINTER’.
b. The machine will not start reception operation in response to arrival of data.
2. When an appropriate correction is made, the machine will automatically generate a
memory clear list. If an error (e.g., jam) occurs during output, the machine goes back to
1. above.
If set to ‘0’, on the other hand, the machine will sound the alarm and enters standby state.
