2
2
2-21
2-21
Technology > Processing Tray Unit > Swing Height Detection Control
Technology > Processing Tray Unit > Swing Height Detection Control
Stack Delivery Operation
Trailing edges of the sheets stacked in the processing tray unit are gripped by driving the
gripper base motor (M116) and gripper motor (M117), and the paper stack is delivered to the
stacking tray.
When the stack consists of 10 or fewer sheets as long as or shorter than 216 mm or it
consists of two or fewer sheets longer than 216 mm, sheets gripped by the gripper are
delivered faster than usual.
Gripper
F-2-33
F-2-33
Swing Height Detection Control
The height of the sheets stacked in the processing tray is detected by the swing height
detection sensor (S118) and the height of the swing unit is adjusted appropriately (during
stacking of a sheet in the processing tray) to lessen the damages (scratches, etc.) to the
image due to abrasion between the previously stacked sheet and the newly delivered sheet.
Swing Guide Height Detection Lever
Swing Guide
Swing Guide Height Detection Sensor
F-2-34
F-2-34
Summary of Contents for Staple Finisher-D1
