4
4
4-17
4-17
Parts Replacement and Cleaning Procedure > External Cover/Internal System > Removing the Upper Cover > Procedure
Parts Replacement and Cleaning Procedure > External Cover/Internal System > Removing the Upper Cover > Procedure
CAUTION:
When installing the Rear Cover [1], be careful not to trap the harness [5].
[5]
[1]
F-4-35
Removing the Upper Cover
■
Preparation
1) Remove the Finisher Unit from the connected equipment(Refer to page 4-9).
2) Remove the Staple Cartridge(Refer to page 4-22).
3) Remove the Front Cover(Refer to page 4-15).
4) Remove the Rear Cover(Refer to page 4-16).
■
Procedure
CAUTION:
When removing the Upper Cover [1], be sure to place it with the Trailing Edge Sheet
[2] up while paying attention not to deform the Trailing Edge Sheet [2] and the Static
Eliminator [3].
[2]
[3]
[1]
[2]
F-4-37
F-4-36
Summary of Contents for Staple Finisher-S1
