4
4
4-25
4-25
Parts Replacement and Cleaning Procedure > Major Units > Removing the Main Paddle > Procedure
Parts Replacement and Cleaning Procedure > Major Units > Removing the Main Paddle > Procedure
Removing the Main Paddle
■
Preparation
1) Remove the Finisher Unit from the connected equipment(Refer to page 4-9).
2) Remove the Staple Cartridge(Refer to page 4-22).
3) Remove the Front Cover(Refer to page 4-15).
4) Remove the Rear Cover(Refer to page 4-16).
5) Remove the Upper Cover(Refer to page 4-17).
■
Procedure
CAUTION:
Be sure to perform the work while keeping contact with the 4 new Main Paddles [1] at a
minimum at disassembly/assembly.
[1]
[1]
F-4-57
F-4-56
1) Turn the Sensor Flag [1] to provide access to the 4 [A] parts of the Main Paddle as shown
in the figure below.
[1]
[A]
[A]
2) Remove the 2 Main Paddles [1].
• 2 Bosses [2]
[2]
[2]
[1]
F-4-58
F-4-59
Summary of Contents for Staple Finisher-S1
