6
6
Installation
Installation
6-10
6-10
Installation > Operation Setting > Operation Setting > Fax communication test
Installation > Operation Setting > Operation Setting > Fax communication test
Operation Setting
Operation Setting
■
Type setting
Select the country/region of the FAX Board in Service Mode: FAX > TYPE
This setting performs the parameter settings to match the communication specification of the
country/region.
1) Set the TYPE of country/region to install this machine, and then press OK.
Service Mode > FAX > TYPE
2) Turn OFF and then ON the main power switch to enable the setting value.
■
Basic Setting
NOTE:
When “System Manager Information Settings” is set, it is required to log in as a system
manager in accordance with instructions from the user administrator.
In this section, make only minimum settings required for FAX communication.
• User telephone number
Settings/Registration > Function Settings > Send > Fax Settings > Set Line > Line 1 >
Register User Telephone No.> Enter the fax number > OK
• Type of telephone line
Settings/Registration > Function Settings > Send > Fax Settings > Set Line > Line 1 >
Select Line Type > Select the type of the connection line > OK
■
Fax communication test
Perform the communication test to check if the fax function works properly.
1) Switch the screen to the Send/Fax screen.
2) Send a test original from the equipment to a remote unit with which a communication test
can be performed and check if it can be sent correctly.
3) Send a test original from the remote unit for a communication test to the equipment and
check if it can be received correctly.
