Canon Super G3 FAX Board-T1, Installation Procedure

Chapter 1　

12

1.3 Checking the Opera-

tion

1.3.1 Setting the Type

0010-8088

1) Connect the iR machine's power plug to the power

outlet, and turn on its main power switch.

2) In service mode, check to make sure that the type

setting is set to the country or the region in which
the machine will be used; i.e.,

2-1) Start service mode as follows:

User Mode key > 2 > 8 > User Mode key
[#SSSW] appears.

2-2) Press [ 

 ] 3 times; when [#CLEAR] ap-

pears, press [OK].

2-3) Press [ 

 ] 4 times; when [TYPE] appears,

press [OK].

2-4) Press [ 

 ] or [

] to bring up the desired

country or region; then, press [OK].

1.3.2 Basic Settings

0010-8093

The following settings are a minimum set of settings
you must make to enable fax communications:
- User Telephone Number

User Mode key > [fax setup] > [basic settings] >
[set user telephone number] > user telephone num-
ber

- Telephone Line Type

User Mode key > [fax setup] > [basic settings] >
[select line type] > select line type

1.3.3 Communications

Test

0010-8098

Conduct a communications test to make sure that the
fax functions operate normally.
1) Press [fax] and then [on-hook] in sequence to see

that a dial tone is heard. If not, check to make sure
that the telephone cord is correctly connected to the
machine and the wall modular jack.

2) When a dial tone has been heard, type in an appro-

priate telephone service number (e.g., time service)
to make sure that a connection is made normally. If
the attempt fails, check to make sure that the type of
the line you selected in user mode and the type of
the actual line match.

3) Type in a telephone number that you can use for

communications testing, and send a test original to
it to see that transmission is normal.

4) Have an original sent to the machine to make sure

that reception is normal.