This allows you to move quickly through still pictures recorded anywhere on a
tape (photo search) or between different days or areas of recording (date search).
• You can only use this function from the wireless controller.
1. Press down and slide the POWER switch to VCR.
2. Press the SEARCH SELECT button to choose between photo/date
search.
• PHOTO SEARCH or DATE SEARCH is shown in the display for a few
seconds.
3. Press the
-
and
+
buttons to move backwards or forwards
through the still pictures or between different days of recording.
• Press once to move to the start of the previous/next still picture or day on
the tape.
• You can press more than once to move to the corresponding still picture or
day (up to a maximum of 10 times), e.g. press the
+
button 5 times to
move forward 5 still pictures or days.
• PHOTO SEARCH/DATE SEARCH appears in the middle of the display
alongside the
-
or
+
mark and number search through. The recording
mode is also shown (SP/LP).
39
E
Using the Full
Rang
e of Features
P
OFF
VCR
POWER
SEARCH
SELECT
Searching the Tape (Photo Search/Date Search)
Notes:
• Press
3
(stop) to end your search.
• If you begin a search very close to the start of a recorded still picture during
photo search, the camera may skip straight past it.
• When you have set the area for the World Clock, date search also looks for the
change in date based on the adjusted time.
• A date/area cannot be identified if the total recording time on that day/area was
less than one minute.
• Date search playback may start just before or after the beginning of the located
section.
• If the data code is not displayed correctly you will not be able to operate the
date search correctly.
