1-8
Setting the Administrator Password, LAN, IPv6, DNS, etc. (Network)
LAN
(1) [IP Address Setting]
Select [
Auto (DHCP)
] or [
Manual
] as the address setting mode. If [
Auto (DHCP)
] is selected,
the values automatically acquired from the DHCP server will be entered in [
IP Address
],
[
Subnet Mask
] and [
Default Gateway Address
]. If [
Manual
] is selected, directly enter the
values appropriate for the environment in which the camera is used.
(2) [IP Address]
If [
Manual
] was selected in (1), enter a fixed IP address.
(3) [Subnet Mask]
If [
Manual
] was selected in (1), enter the subnet mask specified for each network.
(4) [Default Gateway Address]
Enter an appropriate value if [
Manual
] was selected in (1). Be sure to set the default gateway
address when connecting the camera to a subnet different from that of the viewer.
(5) [LAN Interface]
Select [
Auto
], [
Full Duplex
] or [
Half Duplex
]. Normally [
Auto
] should be used.
(6) [Maximum Packet Size]
Enter the maximum transmission unit. Normally the default setting of 1500 needs not be
changed.
COP
Y
