1-9
Setting the Administrator Password, LAN, IPv6, DNS, etc. (Network)
1
1
D
etailed Settings
IPv6
(1) [IPv6]
Select [
Disable
] or [
Enable
] regarding the use of IPv6.
(2) [IPv6 Address]
If [
Enable
] is selected for IPv6, an automatically acquired address will be shown.
Note
z
For [
IP Address
], [
Subnet Mask
] and [
Default Gateway Address
], contact your network
administrator.
z
If any of the [
IP Address
], [
Subnet Mask
] and [
Default Gateway Address
] settings is wrong,
network access may be disabled. In this case, use VB Initial Setting Tool Ver. 5.0.1 to set
the address again. See "Perform Initial Setting of the Camera" (
Start Guide
).
z
If the [
IP Address
], [
Subnet Mask
], [
Default Gateway Address
], [
LAN Interface
] or
[
Maximum Packet Size
] setting is changed, the camera may become no longer accessible
from the active browser. Check beforehand the precautions explained in "Notes" in "Setting
the Items Requiring Rebooting (Reboot Item)" (
P. 1-46). Also check the precautions in the
same section before changing each setting in "IPv6" (
z
If [
Auto (DHCP)
] is selected as the address setting mode, the IP address may not be
assigned correctly in certain environments, such as when a router is present between the
DHCP server and this camera. In this case, assign a fixed IP address by selecting
[
Manual
].
z
If you are using IPv6, set 1280 or greater value under [
Maximum Packet Size
].
Tip
z
If optical fiber or ADSL is used, slightly decreasing the maximum packet size may increase
the sending efficiency.
z
The IP address assigned by [
Auto (DHCP)
] can be checked using the VB Initial Setting
Tool.
Tip
In an environment where IPv6 cannot be used, the [
IPv6 Address
] field remains blank even
when [
Used
] is selected for IPv6.
COP
Y
