2-13
Motion Detection Setting Tool
VBAdmin T
ools
(8)[Details]
When this check box is selected, you can enter [
Sensitivity
], [
Size
] and [
Duration
] values.
If the check box is not selected, [
Duration (sec.)
] is fixed to [
0.2
].
4.
Check the motion detection status of the camera.
To check the level of motion detection operation based on the specified settings, select the
[
Display motion detection status of the camera
] check box. The motion detection status will be
shown by the icons specified below.
If the [
Display motion detection status of the camera
] check box is selected, the settings
cannot be selected. To save the settings, clear this check box.
Tip
z
Even when a change has occurred in the image shown inside the viewer's motion detection
area frame, the camera will not recognize it as [
Motion
] if the [
Sensitivity
] setting is low.
Even when the sensitivity is raised, the camera mode will not change to [
Detected
] unless
the part of the area frame that has moved meets the [
Size
] and [
Duration
] settings for
motion.
z
You can also select the setting area by clicking a desired motion detection area frame in
the viewer. The selected detection area frame is shown by blue solid lines.
z
By setting the Selected areta to [
Not specified
], you can show the detection statuses for all
motion detection areas at once. Clicking a point in the viewer where no area frame is set
has the same effect.
Note
z
If a proxy server is used, the video frame rate may drop depending on the proxy load.
Accordingly, it is recommended that you don't connect the camera via a proxy while this
function is set.
z
It is recommended that the motion detection level be set in a condition as close as possible
to the condition in which the camera is actually used.
[
Detection disabled
]
[
Detected
]
[
Not detected
]
COP
Y
