1-16
Setting the Camera Control and External Device Name (Camera)
Camera Control
[Digital Zoom]
Select [
Enable
] or [
Disable
] for digital zoom.
* The higher the digital zoom ratio, the lower the image quality becomes.
Day/Night
(1) [Mode]
Select [
Manual
] or [
Auto
] as the Day/Night mode.
If [
Manual
] is selected, you can manually switch [
Day Mode
] and [
Night Mode
] using the
Admin Viewer Night Mode function (
If [
Auto
] is selected, set [
Switching Brightness
] and [
Response (sec.)
] according to the
environment in which the camera is installed as well as the desired switching condition.
(2) [Switching Brightness]
Set the brightness at which the Day mode and Night mode will be switched. Select [
Darker
],
[
Slightly Darker
], [
Standard
], [
Slightly Brighter
] or [
Brighter
]. Select [
Darker
] to capture video
in color whenever possible.
Select [
Brighter
] to reduce noise. Note that this will cause the camera to switch to black &
white earlier.
(3) [Response (sec.)]
Set the time in seconds needed to make judgment on day/night mode switching. Select [
5
],
[
10
], [
20
], [
30
] or [
60
].
If the brightness remains above or below the level set in (2) for the number of seconds set
above, the day mode and night mode will switch.
Select [
30
] or [
60
] if the brightness changes frequently due to passing of a light source in
front of the camera, etc. Select [
5
] or [
10
] if the brightness does not change much.
COP
Y
