73
S
etting the U
s
er Bit
Setting the User Bit
The user bit can be selected from the date or the time of recording, or an identification code consisting of
8 characters in the hexadecimal system. There are sixteen possible characters: the numbers 0 to 9 and the
letters A to F. The user bit is recorded with XF-AVC clips and can be output from the SDI OUT terminal
(
z
only) and HDMI OUT terminal.
Setting an Hexadecimal Code
1 Open the [U
s
er Bit
S
etting
s
]
s
creen.
>
[
3
#
Recording Setup]
>
[User Bit Type]
>
[
Setting]
>
[
i
]
• The user bit setting screen appears with an orange selection frame on the leftmost character.
• Select [Reset] to reset the user bit to [00 00 00 00] and return to the previous screen.
2
S
elect a character you want to change and then
s
elect [
Î
] or [
Í
] to change it a
s
nece
ss
ary.
• Change the rest of the characters in the same way.
3
S
elect [OK] and then
s
elect [
X
].
• Select [Cancel] to close the screen without changing the user bit.
Using the Date or Time
1
S
elect [U
s
er Bit Type].
>
[
3
#
Recording Setup]
>
[User Bit Type]
2
S
elect [
Date] or [
Time] and then
s
elect [
X
].
NOTES
NOTES
• The user bit will not be recorded with MP4 clips recorded to the card.
Operating modes:
Summary of Contents for XA70
